Latest Services |
 |
| Pluming Installation |
Next remove the corner screws that are securing the top of the old vanity to the countertop. The countertop should then be able to be lifted off of the old vanity. After the countertop has been separated from the vanity, remove the faucet hardware if you plan on reusing the existing faucet. Make sure, however, when purchasing your new vanity countertop that it will support the faucet configuration. After the counter top and faucet have been removed from the work area, unscrew the back and/or side screws that hold the vanity to the wall(s). Then remove the vanity from the bathroom. |
|
|
|
|
|
|
Hot water circulator |
|
In the normal plumbing configuration, the hot water pipe ends at farthest faucet or fixture from the hot water heater, but when a re-circulating system is installed, the hot water pipe continues until it returns to the hot water tank. There are no faucets or fixtures attached to this return line.
In addition, a circulator pump, check valve and control system are installed at the water heater. This system becomes one continuous pipe loop with available hot water when you want it. When the system calls for the water to be heated, the circulator pump turns on and moves the water through the water heater, to each faucet, shower, water appliance, etc. and back through the return water pipe. The recirculation pump can be installed by a certified Maspeth Sewer and Drain Cleaning in about two hours. Be sure all hot water pipes are insulated and leave at least a 2-inch clearance between the hot and cold water lines.
|
| |
| |
|
